JAC HFC1130KR1, repair e-manual
About the manual
Engine type: CA6DF3-18E3
Engine size: 6,74 l.
Power: 180 hp
In the manual you will find
- Step-by-step guide to repair various components and assemblies
- Self-care and maintenance instructions
- Car design and prevention information
- Information for a trip to the service station, if self-repair is not possible
About the manual
Engine type: CA6DF3-18E3
Engine size: 6,74 l.
Power: 180 hp
In the manual you will find
- Step-by-step guide to repair various components and assemblies
- Self-care and maintenance instructions
- Car design and prevention information
- Information for a trip to the service station, if self-repair is not possible
Content
General
- Specifications
- Vehicle model
- VIN
- Tightening torques of bolts and nuts
Engine
- Appearance of CA6DF diesel engines
- Main specification and data for diesel engine
- Main technical specifications
- Data for adjustment and operation
- Fit and wear limits of main parts of diesel engine
- Tightening torque of threaded fasteners for diesel engine
- Adjusting parameters for injection pump
- Technical methods for meeting the emission standard and cautions on operation
- Main technical methods for meeting the emission standard
- Cautions on operation of engines
- Constructions of diesel engine
- Suspension system and peripheral accessories setting
- Lubricating system
- Cooling system
- Fuel system
- Intake and exhaust system
- Turbocharged and inter-cooled system
- Electrical system
- Cautions on operation diesel engines
- Choice of diesel oil
- Choice of lubricating oil
- Choice of cooling water
- Preparations before starting
- Procedures of starting
- Cautions on running
- Cautions on stopping
- Cautions on operating in winter
- Maintenance requirements of diesel engine
- Run-in of new diesel engine and technical maintenance
- Working requirements of maintenance
- Cautions on starting a new or overhauled engine
- Cautions on assembly of diesel engine
- Total technical requirement of assembly of whole machine
- Assembly of cylinder liner
- Assembly of crankshaft
- Assembly of piston-connecting rod assy
- Assembly of camshaft
- Assembly of gear train
- Assembly of cylinder head and value train
- Assembly of flywheel
- Assembly of crankshaft damper or front pulley
- Assembly of peripheral accessory and adjustment of whole machine
- Trouble and remedies
- Difficult to start or failure of the engine to start
- Failure of the engine to develop full power
- Sudden stopping of the engine
- Overspending of the engine
- Abnormal noises in operation
- Unstable running
- Abnormal color of smoke
- Overheating of the engine
- Dilution of oil
- Oil pressure too low
- Mixing of oil and water
- Turbocharger faults
- Starters faults
- Injector faults
- Failure of injection pump
- Failure of governor
- Failure of air compressor
- Increase of fuel consumption
- Increase of oil consumption
- Failure of the fire pre-heating device
Clutch
- Replacement of brake fluid
- Bleeding of clutch system
- Master cylinder
- Booster
Transmission
- Product introduction
- Special reminder
- Transmission maintenance
- Product identification
- Maintenance data
- Failure diagnosis and reason analysis
- CA6T138 transmission disassembling and assembling
Propeller Shaft
- General
- Disassembly and assembly of the propeller shaft
- Disassembly and reassembly of universal joint
- Disassembly and assembly of center bearing
Front axle
- General
- Specifications
- Service standards
- Troubleshooting
- Service procedure
Rear axle
- Instruction of axle’s construct
- Inspection and maintenance
- Assembly and adjust
- Use and maintenance
- Resolve failure
- Mark introducing
Suspension
- Overview
- Technical parameter
- Disassembly
- Reassembly
- Front shock absorber assembly
- Failure diagnosis of front suspension
- Rear suspension
- Failure diagnosis of rear suspension
Brake
- General
- Wheel brake
- Valves
Body
- General
- Bumper
- Front end trim
- Instrument panel and floor consol
- Headlining and interior trim
- Door
- Windshield glass and windows
- Seat and seat belt