Dodge Durango / Dodge Dakota, engine EKG / EVA / EVC (in Russian)

Content

3.7L v6 and 4.7L v8 engines

• General information
• Engine identification
• Possible engine repair procedures
• Top dead center of the piston of the first cylinder
• Cylinder head cover - removal and installation
• Rocker arms and hydraulic lifters - removal, inspection and installation
• Timing chain and sprocket - removal, inspection and installation
• Camshafts - removal, inspection and installation
• Intake manifold - removal and installation
• Exhaust manifold - removal and installation
• Cylinder head - removal and installation
• Crankshaft pulley / vibration damper - removal and installation
• Front crankshaft oil seal - replacement
• Oil pan - removal and installation
• Oil pump - removal, inspection and installation
• Checking, adjusting and installing the flywheel/clutch drive
• Crankshaft rear main oil seal - replacement
• Engine mounts - inspection and replacement

5.7L V8 engines (hemispherical combustion)

• General information
• Possible engine repair procedures
• Top dead center of the piston of the first cylinder
• Cylinder head covers - removal and installation
• Rocker arms and push rods - removal, inspection and installation
• Intake manifold - removal and installation
• Exhaust manifold - removal and installation
• Front crankshaft oil seal and vibration damper - removal and installation
• Timing chain cover, chain and sprockets - removal, inspection and installation
• Cylinder heads - removal and installation
• MDS (multiple displacement system) system - general information and solenoid replacement
• Camshaft and tappets - removal, inspection and installation
• Oil pan - removal and installation
• Oil pump - removal, inspection and installation
• Flywheel / clutch drive - removal and installation
• Crankshaft rear main oil seal - replacement
• Engine mounts - inspection and replacement

Engine overhaul procedures

• General information - engine overhaul
• Checking engine oil pressure
• Cylinder compression test
• Diagnostic checks with a vacuum gauge
• Alternative replacement engine components
• Engine removal - procedures and precautions
• Engine - removal and installation
• Engine overhaul - disassembly sequence
• Pistons / connecting rods - removal and installation
• Crankshaft - removal and installation
• Engine overhaul - assembly sequence
• Engine start and break-in period after engine overhaul

Power supply and exhaust systems

• General information
• Fuel pressure relief procedure
• Fuel pump/fuel pressure - check
• Fuel lines and fittings - repair and replacement
• Fuel tank - removal and installation
• Cleaning and repairing the fuel tank - general information
• Fuel pump / fuel level transmitter - removal and installation
• Air filter housing, air intake and resonator housing - removal and installation
• Accelerator cable
• Fuel injection system - general information
• Fuel injection system - check
• Throttle body - removal and installation
• Fuel rails and injectors - removal and installation
• Service of system of release of the fulfilled gases - the general information

Engine management and emissions

• General information
• On-Board diagnostic system and fault codes
• Accelerator pedal position sensor - replacement
• Battery temperature sensor - replacement
• Camshaft position sensor - replacement
• Crankshaft position sensor - replacement
• Coolant temperature sensor - replacement
• Intake air temperature sensor - replacement
• Knock sensor - replacement
• Manifold absolute pressure sensor - replacement
• Oxygen sensors - description and replacement
• Throttle position sensor - replacement
• Transmission speed sensors - replacement
• Electronic control unit - removal and installation
• Idle system motor - replacement
• Catalytic converter - description, check and replacement
• Evaporative emission system - description and replacement of components
• Exhaust gas recirculation system - description and replacement of components
• Positive crankcase ventilation system - description and test

Customers reviews