Our books can be purchased by cards єPidtrimka!

Content

Introduction

  • A few words about this manual
  • Introduction
  • Vehicle identification numbers
  • Feedback information
  • Acquisition of spare parts
  • Maintenance, tools and devices
  • Starting the engine with an additional power source
  • Lifting a car with a jack and towing
  • Working fluids and lubricants
  • Safety first!
  • Troubleshooting

Operation

  • Instruments and controls
  • Interior conditioning system
  • Maintenance

Vehicle adjustments and maintenance

  • Schedule of regular maintenance
  • Introduction
  • Adjustments - general information
  • Checking the level of working fluids
  • Checking tires and air pressure
  • Replacement of engine oil and filter
  • Checking and replacing the wiper blades
  • Check, maintain and charge the battery
  • Rearrangement of wheels
  • Seat belt inspection
  • Check and replace engine compartment hoses
  • Checking the engine cooling system
  • Checking and replacing the air filter
  • Checking the brake system
  • Check of a suspension bracket, a steering and anther of a semiaxis
  • Exhaust system check
  • Power system check
  • Replacement of the particle filter
  • Checking, adjusting and replacing the auxiliary drive belt
  • Brake fluid replacement
  • Checking and replacing spark plugs
  • Check and replacement of wires of spark plugs
  • Check and replace the crankcase ventilation valve
  • Maintenance of the engine cooling system (draining, rinsing and filling)
  • Replacing filter and automatic transmission fluid

Four-cylinder engines

  • General information
  • Possible repair procedures without removing the engine from the engine compartment
  • The top dead center of the piston of the first cylinder
  • Cylinder head cover - removal and installation
  • Intake manifold - removal, inspection and installation
  • Exhaust manifold - removal and installation
  • Timing belt cover and covers - removal, inspection and installation
  • Crankshaft front oil seal - replacement
  • Camshaft seal - replacement
  • Rockers and hydraulic lifters - removal, inspection and installation
  • Camshafts - removal, inspection and installation
  • Cylinder head - removal and installation
  • Crankcase - removal and installation
  • Oil pump - removal, inspection and installation
  • Drive clutch plate - removal and installation
  • Crankshaft rear crankshaft rear seal - replacement
  • Engine supports - checking and replacing

Engines V6 in volume 3,3 and 3,8 l

  • General information
  • Possible repair procedures without removing the engine from the engine compartment
  • The top dead center of the piston of the first cylinder
  • Cylinder head covers - removal and installation
  • Rockers and pushers - removal, check and installation
  • Intake manifold - removal and installation
  • Exhaust manifolds - removal and installation
  • Crankshaft pulley - removing and installing
  • Crankshaft front oil seal - replacement
  • Chain of drive timing - removal, inspection and installation
  • Hydrocompensators - removal, inspection and installation
  • Cylinder heads - removing and installing
  • Crankcase - removal and installation
  • Oil pump - removal, inspection and installation
  • Oil cooler - removal and installation
  • Drive clutch plate - removal and installation
  • Crankshaft rear crankshaft rear seal - replacement
  • Engine supports - checking and replacing

Engine overhaul procedures

  • General information - engine overhaul
  • Checking engine oil pressure
  • Compression check in cylinder
  • Diagnostic checks with a vacuum gauge
  • Alternative engine replacement
  • Engine removal - procedures and precautions
  • Engine - removal and installation
  • Engine overhauling - sequence of disassembly
  • Camshaft and bearings (models of cars equipped with engines 3,3 and 3,8 l) - removal, check and installation
  • Balancing shafts (models of cars equipped with 2.4 L engines) - removal, inspection and installation
  • Pistons / connecting rods - removal and installation
  • Crankshaft - removal and installation
  • Engine overhaul - assembly sequence
  • Engine starting and running-in period after engine overhaul
  • Analysis of the state of the engine bearings
  • General terms relating to the engine overhaul procedure

Cooling system, heater and air conditioning

  • General information
  • Coolant / antifreeze - general information
  • Thermostat - check and replace
  • Engine cooling fans and electric circuit - check and replace
  • Coolant expansion tank - removing and installing
  • Radiator - removal and installation
  • Water pump - check
  • Water Pump - replacement
  • Intake water line - removal and installation
  • Motor fan resistor / power supply and motor fan assembly - replacement
  • Heater core - replacement
  • Control panel for air conditioning and heater - removal and installation
  • Air conditioning and heating system - check and maintenance
  • Air conditioning compressor - removal and installation
  • Air handling system dryer-removing and installing
  • Condenser air conditioning / cooler working fluid automatic gearbox - removing and installing
  • Control valve - removal and installation
  • Rear air conditioning and heater housing - removing and installing
  • Air conditioning pressure sensor - removing and installing

Power and exhaust systems

  • General information
  • Fuel pressure relief procedure
  • Fuel pump / fuel pressure check
  • Fuel lines and fittings - general information
  • Fuel tank - removal and installation
  • Fuel tank cleaning and repair - general information
  • The fuel filter (only models of cars of 2003) - replacement
  • Fuel pump / fuel pressure regulator / fuel level sensor assembly - removing and installing
  • Fuel pressure regulator - replacement
  • Fuel pump / fuel level sensor assembly - component replacement
  • Air filter housing - removing and installing
  • Accelerator cable - removal and installation
  • Electronic distributed fuel injection (MPI) - general information
  • Fuel injection system - inspection
  • Throttle body - check, removal and installation
  • Fuel rail and injectors - removal and installation
  • Maintenance of the exhaust system - general information

Electric engine system

  • General information, precautions and disconnection of the negative battery terminal
  • Battery - emergency start of the engine from an additional power source
  • Battery - check, remove and install
  • Battery wires - replacement
  • Ignition system - general information and precautions
  • Ignition system - check
  • Ignition coil - replacement
  • Charge system - general information and precautions
  • Charge system - check
  • Generator - removal and installation
  • Start-up system - general information and precautions
  • Starter and chain check
  • Starter - removal and installation

Engine control and emission control systems

  • General information
  • On-board diagnostic system and DTCs
  • Battery temperature sensor - replacement
  • Camshaft position sensor - replacement
  • Crankshaft position sensor - replacement
  • Coolant temperature sensor - replacement
  • Intake air temperature sensor - replacement
  • Detonation sensor - replacement
  • Manifold absolute pressure sensor - replacement
  • Oxygen sensors - general information and replacement
  • Throttle position sensor - replacement
  • Sensor of selected gearbox mode and gearbox temperature sensors - replacement
  • Gearbox speed sensors - replacement
  • The electronic block of management of the engine and transmission - removal and installation
  • No-load system motor replacement
  • Catalytic converter - description, verification and replacement
  • Fuel vapor recovery system - general information and component replacement
  • Exhaust gas recirculation system - general information and component replacement
  • Crankcase ventilation system

Automatic transmission

  • General information
  • Diagnostics - general information
  • Drive shaft seals - replacement
  • Switching cable - removal, installation and adjustment
  • Shift selector lever lock (BTSI) - description, check and replacement of components
  • Electronic gearbox control unit (TCM) (2003-2005 models with four-cylinder engines) - removal and installation
  • Transmission oil cooler - removing and installing
  • Automatic gearbox - removal and installation
  • Overhaul of an automatic transmission - general information

Power shafts

  • Drive shafts - general information and verification
  • Drive shaft - removal and installation
  • Drive shaft replacement

Brake system

  • General information
  • Anti-lock braking system (ABS) - general information
  • Disc brake pads - replacement
  • Disc brake caliper - removal and installation
  • Brake disc - check, remove and install
  • Brake shoe pads - replacement
  • The working cylinder - removal and installation
  • Master cylinder - removal and installation
  • Pressure limiters - check and replace
  • Brake hoses and lines - check and replace
  • Braking system - pumping
  • Brake amplifier - checking, removing and installing
  • Parking brake shoes (car models equipped with rear disc brakes) - replacement
  • Stop light switch - check, replace and adjust

Suspension and steering

  • General Information
  • Bushings of stabilizers of cross-section stability (forward) - removal and installation
  • The rack in gathering (forward) - removal, check and installation
  • Rack / helical spring - replacement
  • Suspension levers - removal, inspection and installation
  • Ball bearings - replacement
  • Hub and bearing assembly (front) - removing and installing
  • Rotary fist - removing and installing
  • Stabilizer of lateral stability (rear) - removal and installation
  • Transverse reactive rod - removal and installation
  • Leaf spring supports - removal and installation
  • Leaf spring - removal and installation
  • Shock absorbers (rear) - removal and installation
  • Rear axle assembly - removal and installation
  • The hub and the bearing in gathering (back) - removal and installation
  • The subframe carrier plate - removal and installation
  • Steering wheel - removal and installation
  • The ends of the transverse steering rods - removal and installation
  • Steering column - removal and installation
  • Steering gear - removal and installation
  • Power steering pump - removal and installation
  • Power steering fluid cooler - removing and installing
  • Power steering system - pumping
  • Wheels and tires - general information
  • Adjusting the angles of installing the front wheels - general information

Body

  • General information
  • Body care
  • Vinyl facing - care
  • Interior upholstery and floor covering - care
  • Body repair - minor damage
  • Body repair - serious damage
  • Locks and awnings - maintenance
  • Windshield and fixed glass - replacement
  • Hood - removal, installation and adjustment
  • Hood retainer and cable - removal and installation
  • Radiator grille - removal and installation
  • Bumper covers - removal and installation
  • Front wing - removal and installation
  • Hood cover - removing and installing
  • Door trim panels - removal and installation
  • Door - removal and installation
  • Trunk doors rack - replacement
  • Lock, lock and door handle - removal and installation
  • Front door glass - removal and installation
  • Rear side window - removal and installation
  • Lifters - removal and installation
  • Mirrors - removal and installation
  • Top console - removal and installation
  • Panels of a steering column - removal and installation
  • Panels for facing the dashboard - removal and installation
  • Rear facing panels - removal and installation
  • Seats - removal and installation

Chassis electrical system

  • General information
  • Troubleshooting the electrical system - general information
  • Fuses and fusible links - general information
  • Breakers - general information and verification
  • Relay - general information
  • Multifunction switch - replacement
  • Ignition lock and lock cylinder - Replacement
  • Switches on the dashboard - replacement
  • Instrument panel - removal and installation
  • Wiper motor - replacement
  • Audio system and speakers - removal and installation
  • Antenna and wires are replacement
  • Rear window heating - inspection and repair
  • Headlight headlight housing - replacement
  • Headlight lamp - replacement
  • Headlights - adjustment
  • Lamp replacement
  • Acoustic signal - replacement
  • Sliding door servomotor - removal and installation
  • Rear-view mirrors with servo drive - general information
  • Cruise control system - general information
  • Electric window system - general information
  • Central locking - general information
  • Daylighting system - general information
  • Airbags - general information
  • Wiring diagrams - general information

Glossary

Only original manuals
Available immediately after payment
Full compliance with the paper edition
100% protection of your payments
(10)

Replacing of front hub bearing (for use on the Dodge Caravan IV / Chrysler Voyager IV models)

Typically, users of our site find this page for the following queries:
undercarriage repair Dodge Caravan, undercarriage Dodge Caravan, front suspension Dodge Caravan, rear suspension Dodge Caravan, front suspension repair Dodge Caravan, rear suspension repair Dodge Caravan, undercarriage repair Chrysler Voyager, undercarriage Chrysler Voyager, front suspension Chrysler Voyager, rear suspension Chrysler Voyager, front suspension repair Chrysler Voyager, rear suspension repair Chrysler Voyager

Sorry, the article is only available in Russian.

To read the article, you need to change the language on the site.