Content
Instruction manual
- Dashboard
- Controls and interior equipment
- Seats and elements of the passive safety system
- Starting the engine
- Driving a car
General Information
- About this guide
- Cars Ford Escape, Mazda Tribute and Ford Maverick
- Vehicle identification numbers
- Acquisition of spare parts
- Methods of service, tools and work equipment
- Lifting the jack and towing a car
- Starting an engine from an auxiliary battery
- Translation of decimal values ??in inches to values in millimeters
- Conversion factors
- Safety first!
- Service fluids and lubricants
- Determining the causes of malfunctions
Daily Care and Maintenance
- Ford Escape and Mazda Tribute car service schedule
- Introduction
- General recommendations for car care
- Checking the levels of service fluids and lubricants (every 400 km or weekly)
- Checking the condition and tire inflation pressure (every 400 km or weekly)
- Replacement of engine oil and oil filter (every 4800 km or once every three months)
- Inspection and replacement of windshield wiper blades (every 12,000 km or once every six months)
- Inspection, maintenance and charging of the battery (every 12,000 km or every six months)
- Checking the cooling system (every 12,000 km or every six months)
- Rearrangement of the wheels (every 12,000 km or once every six months)
- Inspection of seat belts (every 12,000 km or every six months)
- Inspection and replacement of hoses that are in the engine compartment (every 24,000 km or once a year)
- Checking the technical condition of the braking system (every 24,000 km or once a year)
- Checking the technical state of the steering and suspension (every 24,000 km or once a year)
- Checking the technical condition of the fuel system (every 24,000 km or once a year)
- Checking the transmission oil level in the manual transmission (every 24,000 km or once a year)
- Checking the level of the transmission fluid in the transfer case (every 24,000 km or once a year)
- Checking the condition and replacing the air filter (every 24,000 km or once a year)
- Inspection of drive shaft covers (every 24,000 km or once a year)
- Checking the technical condition of the exhaust system (every 48,000 km or every two years)
- Replacing the fuel filter (every 48,000 km or every two years)
- Maintenance of the cooling system (coolant draining, flushing and filling) (every 48,000 km or every two years)
- Replacement of the brake fluid (every 48,000 km or every two years)
- Checking the condition and replacing the drive belt (every 48,000 km or every two years)
- Replacing the transmission fluid of the automatic transmission (every 48,000 km or every two years)
- Changing the oil of the manual transmission (every 48,000 km or every two years)
- Replacing differential oil (4WD versions) (every 48,000 km or every two years)
- Changing the fluid in the transfer case (4WD versions) (every 48,000 km or every two years)
- Replacement of the crankcase ventilation valve (PCV) - 4-cylinder engines (every 96,000 km or every four years)
- Inspection and replacement of spark plugs (check intervals are shown in the maintenance schedule)
- Checking the status of the ignition coil (V6 engines) (every 96,000 km or every four years)
- Inspection and replacement of spark plug wires - 4-cylinder engines (every 96,000 km or every four years)
Four-cylinder engine
- General Information
- Repair procedures that can be performed without removing the engine from the engine compartment
- Determination of the top dead center for the cylinder piston No1
- Cylinder head cover - removal and installation
- Valve clearance - check and adjustment
- Intake manifold - removal and installation
- Exhaust manifold - removal and installation
- Crankshaft Pulley - Removing and installing
- Timing belt (2.0 liter engines) - removal, inspection and installation
- Timing Chain Cover, chain and tensioner - Removing and installing
- Front engine oil seals - replacement
- Camshafts and pushers - removal, inspection and installation
- Cylinder head - removal and installation
- Crankcase - removal and installation
- Oil pump - removal, inspection and installation
- Flywheel - removal, inspection and installation
- Main rear seal
- Engine supports - checking and replacing
The V6 engine
- General information
- Car repair without removing the engine from the engine compartment
- The top dead center (TDC) of the piston of the first cylinder is the location
- Valve mechanism covers - removing and installing
- Intake manifold - removal and installation
- Exhaust manifolds - removal and installation
- Pulley and front crankshaft seal - removal and installation
- Front engine cover - removal and installation
- Drive chains, tensioners and guides - removal, inspection and installation
- Camshafts, hydraulic expansion joints and rocker arms - removal, inspection and installation
- Cylinder heads - removing and installing
- Pallet - removal and installation
- Oil pump - removal, inspection and installation
- Rear main engine oil seal - replacement
- Drive disk - removal and installation
- Engine mountings - inspection and replacement
Major engine repairs
- General information
- Checking the oil pressure
- Compression check in engine cylinders
- Diagnosis with measurement of the degree of dilution
- Alternative methods of engine restoration
- Engine removal - methods and precautions
- Engine - removal and installation
- Engine overhauling - sequence of disassembly
- Pistons / connecting rods - removal and installation
- Crankshaft - removal
- Engine overhaul - assembly sequence
- The first start-up and engine break-in after major overhaul
Cooling, heating and air conditioning systems
- General information
- Antifreeze - general information
- Thermostat - check of working capacity and replacement
- Engine cooling fans - functionality and replacement check
- Expansion tank - removal and installation
- Radiator - removal and installation
- Cooling pump - performance test
- Cooling pump - removing and installing
- Coolant temperature sensor - operation and replacement test
- Resistor and electric motor of the heater fan - replacement
- Control panel for heating and air conditioning - removal and installation
- Heater - replacement
- Air conditioning and heating systems - operation and maintenance check
- Air conditioning compressor - removal and installation
- The filter - the dehumidifier of an air conditioning system - removal and installation
- Condenser for air conditioning - removal and installation
- Compressor clutch cycle switch - replacement
- Drainage pipe of air conditioning system - removal and installation
- Lube oil cooler - removing and installing
Fuel and exhaust system
- General information and precautions
- Pressure relief in the fuel system
- Fuel pump / fuel pressure check
- Fuel lines and their couplings - general information
- Fuel pump / fuel level sensor - Removing and installing
- Fuel tank - removal and installation
- Cleaning and refueling the fuel tank - general information
- Air cleaner - removal and installation
- Throttle cable - removal, installation and adjustment
- Multipoint fuel injection (MFI) - general information
- Fuel injection system - general condition check
- Throttle unit - inspection, removal and installation
- Extinguisher of fuel pulsation - removal and installation
- Fuel receiver and nozzles - removal and installation
- Exhaust system - inspection and replacement of elements
Engine electrical systems
- General information, precautions and battery disconnection
- Battery - emergency start from external battery
- Battery - inspection, removal and installation
- Battery cable replacement
- Ignition system - general information
- Ignition system - prevention
- Ignition coils - replacement
- Charging system - general information and precautions
- Charge system - prevention
- Generator - removal and installation
- Launch system - general information and precautions
- Starter and its electrical circuit - status check
- Starter - removal and installation
Exhaust gas control and engine control systems
- General information
- On-board diagnostic system (OBD) and DTCs
- The camshaft position sensor (CMP) is a replacement
- Clutch pedal position sensor (CPR) - replacement
- Crankshaft position sensor (TFR) - replacement
- Cylinder head temperature sensor (CST) - replacement
- Coolant temperature sensor (ECT) - replacement
- Detonation sensor - replacement
- Airflow meter (MAF) - replacement
- The sensor of rotation of the secondary shaft (OSS) - replacement
- Oxygen sensors - general information and replacement
- Hydraulic power steering system pressure sensor (PSP) - replacement
- Throttle position (TP) sensor - replacement
- Selector lever (TR) - replacement and adjustment
- Turbine shaft speed sensor (TSS) - replacement
- Vehicle speed sensor (VSS) - replacement
- Engine control module (PCM) - replacement
- Idle valve (IAC) - replacement
- Catalytic converters
- Fuel vapor recovery system (EVAP) - general description and replacement of elements
- The EGR system is a general description and replacement of elements
- Crankcase ventilation system (PCV) - general description and replacement of elements
Manual transmission
- General information
- Gear lever - removal and installation
- Shift mechanism (2WD) - removal and installation
- Cables for gear change (4WD) - removal and installation
- Transmission oil seals - replacement
- Manual gearbox - removing and installing
- Repair manual transmission - general information
- Transmission supports - replacement
Automatic transmission
- General information
- Diagnosis - general information
- Selector lever - replacement
- Selector cable - replacement and adjustment
- Additional cooler - removal and installation
- Automatic gearbox - removal and installation
- Automatic transmission repair - general information
Transfer case
- General information
- Rear transmission output shaft o-ring - removal and installation
- Drive shaft oil seal (right) - removing and installing
- Transfer case - removal and installation
- Mode switch
Clutch and transmission
- General information
- Clutch - description and verification
- Clutch master cylinder - removal and installation
- Clutch slave cylinder - removing and installing
- Hydraulic clutch system - pumping
- Clutch elements - removal, inspection and installation
- Releaser and clutch fork - removal, inspection and installation
- Drive shafts - removal and installation
- Drive shaft cover - replacement
- Cardan shaft - removal and installation (all-wheel drive vehicles)
- Seals of the rear axles (all-wheel drive vehicles) - replacement
- Differential (all-wheel drive vehicles) - removal and installation
Brake system
- General information
- Anti-lock braking system - general information
- Disc brake pads - replacement
- Disc brake caliper - removal and installation
- Brake disc - inspection, removal and installation
- Brake shoe pads - replacement
- Service brake cylinder - removal, repair and installation
- Master cylinder - removal and installation
- Hoses and pipes of brake system - inspection and replacement
- Hydraulic braking system - pumping
- Vacuum brake booster - performance check, removal and installation
- Parking brake - adjustment of the mechanism
- Stop light sensor - replacement
Suspension and steering
- General information
- Shock absorber (front) - removal, inspection and installation
- Suspension and suspension spring - replacement
- Stabilizer of lateral stability (front) and its bushings - removal and installation
- Suspension lever (front) - removing, inspection and installation
- Rotary fist and hub - removal and installation
- Hub and bearing (front) - Removing and installing
- Shock absorber (rear) - removal, inspection and installation
- Suspension levers (rear) - removal and installation
- Spring of suspension (rear) - removal and installation
- Hub and bearing (rear) - removal and installation
- Steering wheel - removal and installation
- Steering column - removal and installation
- Tips of steering rods - removal and installation
- Power Steering Pads - Replacement
- Steering gear - removal and installation
- Power steering pump - removal and installation
- Hydraulic power steering system - pumping
- Hydraulic power steering system cooling system cooler
- Wheels and tires - general information
- Wheel alignment angles - general information
Car body
- General information
- Body - service
- Vinyl cladding - maintenance
- Upholstery and carpets - maintenance
- Body repair - minor damage
- Body repair - serious damage
- Loops and locks - maintenance
- Wind and fixed glass - replacement
- Hood cover - removal, installation and adjustment
- Latch and bonnet bonnet cable - removal and installation
- Bumpers - removal and installation
- Front wing - removal and installation
- Radiator grille - removal and installation
- Interior liner and chute - removal and installation
- Facing panels of doors - removal and installation
- Doors - removal, installation and adjustment
- Latch, lock cylinder and door handle - removal and installation
- Glasses of door windows - removal and installation
- Lift - removal and installation
- Mirrors - removal and installation
- Rear hinged door - removal, installation and adjustment
- Remote actuator, latch of the folding door and its windows - removal and installation
- Central console - removal and installation
- Dashboard cover
- Covers of a casing of a steering column - removal and installation
- Instrument panel - removal and installation
- Seats - removal and installation
Electrical equipment of a car
- General information
- Determining the causes of faults in electrical circuits - general information
- Fuses and inserts - general information
- Circuit breakers - general information
- Relay - general information and validation
- Circuit breaker / hazard warning light interrupter - operation check and replacement
- Switch and ignition lock cylinder - replacement
- Switches located on the steering column - replacement
- Switches located on the dashboard - replacement
- Instrument panel - removal and installation
- Windshield wiper motor - operation check and replacement
- Car radio and speakers - Removing and installing
- Antenna and its cable replacement
- Rear window heater - performance check and repair
- Headlamp bulbs - replacement
- Headlights - adjustment
- Headlights - replacement
- Signal replacement
- Replacement of lighting fixtures
- Side mirrors with electric drive - description
- Speed-keeping system - description
- Power windows - description
- Automatic door locks - description
- Daylight-saving lighting (DRL) - general information
- Airbag system - general information and precautions
- Wiring diagrams - general information
Alphabetical index
Replacing the electric motor of the heater fan (for use on the Ford Escape I model)
Typically, users of our site find this page for the following queries:
cooling system diagram Mazda Tribute, cooling fan Mazda Tribute, cooling radiator Mazda Tribute, cooling system diagram Ford Maverick, cooling fan Ford Maverick, cooling radiator Ford Maverick, cooling system diagram Ford Escape, cooling fan Ford Escape, cooling radiator Ford Escape
Sorry, the article is only available in Russian.
To read the article, you need to change the language on the site.