Iveco EuroTech CURSOR 390–430 / EuroStar CURSOR 430, wiring diagrams
About the manual
Engine type: disel
In the manual you will find
- wiring diagram for Iveco EuroTech CURSOR 390–430 / EuroStar CURSOR 430
- electrical equipment Iveco EuroTech CURSOR 390–430 / EuroStar CURSOR 430
About the manual
Engine type: disel
In the manual you will find
- wiring diagram for Iveco EuroTech CURSOR 390–430 / EuroStar CURSOR 430
- electrical equipment Iveco EuroTech CURSOR 390–430 / EuroStar CURSOR 430
Content
Introduction
- General precautions when working with electrical / electronic components
- Concepts of mass and electromagnetic compatibility
- CAN communication line concept
- Technical codes
- Graphic symbols and abbreviations
General information
- Basic system description
- Technical and electrical characteristics
- Cabin arrangement
- Engine device
- Frame device
- Cab tilted
- Interior of the car
- Power network
- Negative chain
- Ground points
- Positive chain
- Launch
- Main components
- Main control unit
- Dashboard and instrument groups
- Starter
- Generator
- Lever steering wheel
- Ignition lock
- Engine control unit (ECU)
- Front connector
- Rear connector
- Cable connector codes (ST)
Special electrical circuits
- ABS / EBS
- Description and principle of operation
- Components
- APU (Air handling unit)
- ASR (Traction control)
- EBL (Electronic brake force limiter)
- ABS (Anti-lock braking system)
- Pin assignment of the ABS control unit
- EBS (Electronic braking system)
- The main components of the EBS system. Duplex distributor with electrical converter
- Front axle proportional control valve
- Front axle ABS solenoid valves
- Electro-pneumatic rear axle modulator
- Trailer brake servo valve
- Diagnostics
- Diagnostics with MODUS
- Diagnostics with UNITESTER
- Diagnostics with IWT (Iveco electrical equipment tester)
- Repair operations
- Troubleshooting
- EDC MS6.2
- Description and principle of operation
- EDC control unit
- Location and identification of EDC MS6.2 system components
- Components
- Pressure sensor
- Fuel temperature sensor
- Boost pressure sensor
- Coolant temperature sensor
- Manifold air temperature sensor
- Diagnostics
- Connecting to the EDC control unit wiring for the engine (a) and the cab / frame (b)
- Troubleshooting procedure
- Engine brake
- ECAS
- Description and principle of operation
- Location of components in the cab of EuroTech / EeuroStar cars
- Electrical wires in the car
- Electronic control unit ECAS (ECU)
- Main components of the system
- Level sensor
- Axle load limiting valve
- Air suspension low pressure sensor
- Signal booster
- Electro-pneumatic valve
- Electro-pneumatic axle valve "9820" / "78242"
- Electro-pneumatic valve "9838" / "78243"
- Electro-pneumatic distributor of the rear axle "9838" / "78243"
- Electro-pneumatic distributor of the rear axle "9838" / "78243"
- Electro-pneumatic distributor of the rear axle "9838" / "78243"
- Remote control "8568" / "85065"
- Axle lifting system
- Description and principle of operation
- Lowering the frame
- Frame alignment
- Auxiliary axle control (pneumatic lift system)
- Raising an additional bridge
- Lowering the additional bridge
- Assistance at the beginning of lifting the axle (vehicles with air suspension)
- Additional steer axle steering
- Location of the main components of the hydraulic system on the vehicle
- Functional diagram of the hydraulic system
- Calibration of the electronic control unit
- Electronic control unit programming
- Diagnostics
- System diagnostics
- Repair operations
- Activating and reading flashing code
- Immobilizer
- Description and principle of operation
- System features
- Components
- Electronic control unit "immobilizer"
- li>
- Electronic control unit "immobilizer"
- Antenna
- Ignition lock
- Control lamp
- Electronic keys (2 pcs.)
- Code card
- Component locations - cable routing
- Emergency start procedure
- Diagnostics with MODUS
- Diagnostic connector
Wiring diagrams
- Conventions
- Scheme №1: starting the engine from the driver's seat
- Scheme №2: starting from the engine compartment
- Scheme №3: warming up
- Scheme №4: charging
- Scheme №5: instruments (fuel level - coolant temperature and voltmeter)
- Scheme №6: instruments (pressure in the engine lubrication system and air pressure in the pneumatic drive of the brakes)
- Scheme №7: devices (tachograph - tachometer)
- Scheme №8: control lamps
- Scheme №9: side lights (inside the cab)
- Scheme №10: side lights (outside the car)
- Scheme №11: low and high beam headlights
- Scheme №12: additional headlights and rear fog lights
- Scheme №13: direction indicators and hazard warning lights
- Scheme №14: brake lights - reversing lights - sound signal
- Scheme №15: windshield wiper
- Scheme №16: interior lighting and auxiliary equipment
- Scheme №17: rear-view mirrors on the car wings
- Scheme №18: electric windows
- Scheme №19: basic anti-lock braking system ABS
- Scheme №20: electronic braking system EBS
- Scheme №21: EDC diesel engine electronic control unit
- Scheme №22: EDC (connector a)
- Scheme №23: vehicles equipped / not equipped with a power take-off and CAN