Наши книги можно приобрести по карточкам єПідтримка!

Content

Introduction

  • Is it worth to install gas-cylinder equipment (GBO)
  • The difference between propane and methane

General information

  • Propane-butane
  • Chemical composition of propane-butane mixture
  • Octane number
  • Detonation in the engine
  • Compression ratio
  • Compression
  • TDC
  • Ignition timing

Classification of GBO

The composition of the GBO

  • Second generation GBO injection kit
  • Injection kit of 3rd generation GBO
  • Injection kit of the 4th generation GBO

Gas reducer

  • The device and operation of the gas reducer
    on an example of an electronic reducer Tomasetto AT-07

Adjustment of the 2nd and 3rd generation GBO reducer

  • 1st stage - power adjustment (only for GBO 2nd generation)
  • 2nd stage - adjustment of the XX

Gas engine operation

  • What happens in the cylinder
  • Why combustion is disrupted
  • What happens when the engine is running on gas
  • Ensuring the efficiency of the catalyst
  • Maintenance of the coordination of a signal of a lambda-probe (oxygen gauge) at work on gas with gasoline
    electronic engine control unit (ECU)

What burns in the engine?

  • Risk of fire of a car

Other issues

  • Advantages of GBO
  • What are the bottles
  • Gas consumption relative to gasoline. Dynamics on gas
  • Does the presence of GBO to work on gasoline
  • Getting Started on cold weather
  • How often to change the air filter when driving on gas
  • GBO and spark plugs

A little general about the systems of the 4th generation GBO

  • The gas injection system "Favorit"
  • Gas injector

About manufacturers

  • Standard layout of the 2nd generation GBO installation
  • Installation
  • Scheme of installation of third generation GBS
  • Scheme of installation of the 4th Generation GBO
  • Variants of the arrangement of equipment of different cars (photo)
  • Safety measures for maintenance and operation of GBO

Manuals for tuning gas systems of the IV generation

  • Instruction to the Dream XXI system of sequential gas injection
  • Connection and programming instructions for the Digitronic-DGI controller
  • Instructions for configuring Diego controllers (AKME)
  • Connection and programming instructions for the ZENIT controller
  • Installation and operation of LOV ECO 1
  • Installation and operation of LOV ECO 2
  • Gisn Software user's guide
  • Preliminary stage
  • Agis gas injection controller software documentation
  • Advanced settings
Only original manuals
Available immediately after payment
Full compliance with the paper edition
100% protection of your payments
(9)

What burns out in the engine

Sorry, the article is only available in Russian.

To read the article, you need to change the language on the site.