Our books can be purchased by cards єPidtrimka!

Content

Introduction

  • Is it worth to install gas-cylinder equipment (GBO)
  • The difference between propane and methane

General information

  • Propane-butane
  • Chemical composition of propane-butane mixture
  • Octane number
  • Detonation in the engine
  • Compression ratio
  • Compression
  • TDC
  • Ignition timing

Classification of GBO

The composition of the GBO

  • Second generation GBO injection kit
  • Injection kit of 3rd generation GBO
  • Injection kit of the 4th generation GBO

Gas reducer

  • The device and operation of the gas reducer
    on an example of an electronic reducer Tomasetto AT-07

Adjustment of the 2nd and 3rd generation GBO reducer

  • 1st stage - power adjustment (only for GBO 2nd generation)
  • 2nd stage - adjustment of the XX

Gas engine operation

  • What happens in the cylinder
  • Why combustion is disrupted
  • What happens when the engine is running on gas
  • Ensuring the efficiency of the catalyst
  • Maintenance of the coordination of a signal of a lambda-probe (oxygen gauge) at work on gas with gasoline
    electronic engine control unit (ECU)

What burns in the engine?

  • Risk of fire of a car

Other issues

  • Advantages of GBO
  • What are the bottles
  • Gas consumption relative to gasoline. Dynamics on gas
  • Does the presence of GBO to work on gasoline
  • Getting Started on cold weather
  • How often to change the air filter when driving on gas
  • GBO and spark plugs

A little general about the systems of the 4th generation GBO

  • The gas injection system "Favorit"
  • Gas injector

About manufacturers

  • Standard layout of the 2nd generation GBO installation
  • Installation
  • Scheme of installation of third generation GBS
  • Scheme of installation of the 4th Generation GBO
  • Variants of the arrangement of equipment of different cars (photo)
  • Safety measures for maintenance and operation of GBO

Manuals for tuning gas systems of the IV generation

  • Instruction to the Dream XXI system of sequential gas injection
  • Connection and programming instructions for the Digitronic-DGI controller
  • Instructions for configuring Diego controllers (AKME)
  • Connection and programming instructions for the ZENIT controller
  • Installation and operation of LOV ECO 1
  • Installation and operation of LOV ECO 2
  • Gisn Software user's guide
  • Preliminary stage
  • Agis gas injection controller software documentation
  • Advanced settings
Only original manuals
Available immediately after payment
Full compliance with the paper edition
100% protection of your payments
(9)

Ignition timing

Sorry, the article is only available in Russian.

To read the article, you need to change the language on the site.